#Serial tags labels serial number#

A list of the certification label(s) number(s) that are affixed to each transportable manufactured section under 3280.8.The statement: This manufactured home is designed to comply with Federal manufactured Home Construction and Safety Standards in force at the time of manufacture.

#Serial tags labels serial number#

The serial number and model designation of the unit, and the date the unit was manufactured.

The name and address of the manufacturing plant in which the manufactured home was manufactured.

The Data Plate has maps of the United States to inform the owner of the Wind Zone, Snow Load, and Roof Load of the home the Data Plate Will contain the following information:

Or the inside of a bathroom cabinet door.

The вЂњData PlateвЂќ is a paper label affixed inside the home and is the size of a standard sheet of paper (8 1/2вЂќ x 11вЂќ). There are 2 labels that are actually ATTACHED to the home at the time it leaves the factory:

VIN number found on the title (NOT attached to the home).

Title Issued By The State (NOT attached to the home).

Certification Number (Found on HUD Tag).

6 Digit Number вЂ“ This is stamped sequential by the label maker and used as an identifier for the home.

What a mouthful! What does it mean? Just the third party inspection agency that inspected the home at the factory.

First 3 letters вЂ“ These letters identify the production inspection primary inspection agency, which the Secretary shall assign.

These laws are set by HUD in the Federal manufactured Home Construction and Safety Standards Law. What it means is that the manufactured home was inspected in the factory before it left and that the home was built to all of the requirement by HUD at the date of manufacture. This is known as вЂњthe certification label numberвЂќ. This identifying number is different for every manufactured home in the country. There will be 3 letters, then a dash, followed by 6 numbers. You will find within the first sentence of the aluminum HUD Tag a number that is etched in. The labels shall be stamped with numbers sequentially.вЂќ What Is The Label Number That On The HUD Tag? Each label shall be marked with a 6 digit number which the label supplier shall furnish. The label number shall be etched or stamped with a 3 letter designation which identifies the production inspection primary inspection agency and which the Secretary shall assign. in size and shall be permanently attached to the manufactured home by means of 4 blind rivets, drive screws, or other means that render it difficult to remove without defacing it. Section 328.11(b) states, вЂњThe label shall be approximately 2 in. The certification label (also known as a HUD tag) is a metal plate that is affixed to the outside of the manufactured home. See data plate.вЂќ What Is The HUD Requirement For The Tag? вЂњThe manufacturer certifies to the best of the manufacturerвЂ™s knowledge and belief that this manufactured home has been inspected in accordance with the requirements of Department of Housing and Urban Development and is constructed in conformance with the federal manufactured home construction and safety standards in effect on the date of manufacture. HUD TagД®very manufactured home вЂњred tagвЂќ that is manufactured in the U.S.

But, everything is required to be etched into the metal tag, so you should be able to read the label. You might find a pink tag, or one that just looks silver, depending on how old the home and tag is. The tags start out as red, but like a red car, they tend to fade badly over time.

The official name given by HUD is the вЂњCertification LabelвЂќ. It is sometimes referred to as the вЂњred tagвЂќ. Since the tag is silver writing over a red background with silver writing. This has been required by HUD on every manufactured home built since June of 1976. This metal tag generally should be attached to the rear of the home, usually about a foot from the side and a foot up from the bottom. In general, people will refer to this as the HUD label. A single wide has one tag, and a double wide will have two tags. The tag, issued by HUD (Department of Housing and Urban Development) is a 2вЂќ by 4вЂќ plate made of metal that is attached to an exterior wall of each section of a mobile home. What If The HUD Tag Or Data Plate Is Missing?.So What Identifiers Are Part Of The Manufactured Home?.What Is The Label Number That On The HUD Tag?.What Is The HUD Requirement For The Tag?.